November 17, 2010
OSPF OVER FRAME RELAY
Posted by: admin : Category:
Log In
Main Menu
Recent Posts
- Troubleshooting VSS Failure
- GNS3 is Holding a Network Topology Photo Challenge
- Packet Tracer Lab Securing Router Admin Access
- New Cisco IOS Requirements for Certification Exams
- CCIE Service Provider GNS3 lab
Recent Comments
- on Packet Tracer Lab Securing Router Admin Access
- on Free Cisco Lab GNS3 Scenario CCIE Final Assessment
- on GNS3 is Holding a Network Topology Photo Challenge
- on New Cisco IOS Requirements for Certification Exams
- on Basic VSS Pair Configuration
Helpful Resources
August 20th, 2012 at 9:49 am
Greet you,
i have just installed gns3. I have some issue if I have run more than 3 routers. After I installed dynagen-0.11.0_win_setup it may be ok. I want you ask if you could put here desription of the configuration. How to configure serial interface with frame relay switch. Or how you imagine the all lab. (vlans, ..) This lab is atract for me and I want to practise my ccnp too. If you be so kind and put here some text documents with the instruction.
Thank you very much for your time.
With regards Zdenko Michalčík, Slovak republic